Autosampler Issue
Hello everyone,
recently I have some troubles with the autosampler of the cytof 2. Mostly with the sample introduction. Every time the plasma goes of when I start the tuning. Its right before the autosampler is loading the plate but even when the plasma is off the machine continues to do the tuning until I stop it then.
I did a dry-run where I took out the nebulizer and blocked the opening to see if its maybe a software issue but the plasma stayed on. During that I observe the spray and it looked good and constant. Then I changed the tubing that connects the sampler with the cytof resulting in the plasma shutdown.
But if I switch back to manual sample introduction I don't have a problem at all with the plasma. Does anyone has such similar problems with the autosampler?
Thanks!
recently I have some troubles with the autosampler of the cytof 2. Mostly with the sample introduction. Every time the plasma goes of when I start the tuning. Its right before the autosampler is loading the plate but even when the plasma is off the machine continues to do the tuning until I stop it then.
I did a dry-run where I took out the nebulizer and blocked the opening to see if its maybe a software issue but the plasma stayed on. During that I observe the spray and it looked good and constant. Then I changed the tubing that connects the sampler with the cytof resulting in the plasma shutdown.
But if I switch back to manual sample introduction I don't have a problem at all with the plasma. Does anyone has such similar problems with the autosampler?
Thanks!